◆Model: W40VR multifunction underwater photographing Light
◆Bulb: White CREE XM-L U2 LED *4 (max 2600 Lumens); Red CREE
XP-E N3 LED*2 (max 200 Lumens),Purple 6565 LED*2,UV LED*2
◆Color temperature: White LED: 5700-7000k;
◆Output levels. Red -White -White low>Red
◆Runtime: High: 60 min(White ),Low:300 min (Red,Purple,UV)
◆Reflector: no hotspot design, no reflector
◆Body material: Durable aircraft-grade aluminum.
◆Angle of light beam: 120°
◆Surface treatment: Premium Type III hard-anodizing.
◆Battery: 32650 Li- ion battery *1.
◆With battery over-discharging protection, polarity reversing
◆Waterproof: 100 meters underwater
◆Dimensions: 124.8mm (length)*50mm (dia. of head).
◆Impact resistance: 1.5M.
◆Underwater Weight: 220 grams (with battery)
◆Operation Instruction: Successive switching ON-OFF within two
seconds to cycle through white, red, purple,UV.
1. Remove the tail by turning counter-clockwise.
2.Remove used batteries and replace with fresh batteries as shown by
the polarity stickers.
3.Mount the tail by turning clockwise. DO NOT ACTIVATE IT YET.
1. Plug the charger in the wall power socket, the indicator light is green
in the free-load status.
2. Put the battery in the slot of the charger.
3. The indicator light is red if the battery is not fully charged; it will turn
green after fully charged.
4. Take out the fully charged battery and use them in the diving light.
Turn the tail clockwise until the light activates. DO NOT
To turn the light off, back off the tail counter-clockwise until the light
Continue to back off for approximately one full turn to eliminate the
possibility of the light activating accidentally in storage. For
underwater use, backing off too much will allow water to enter past the
Successive switch ON-OFF within two seconds to cycle through high,
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged o-ring or
mating lens surface as this can cause the light to flood under pressure.
Remove any salt deposits, sand, dirt, or other foreign matter from the
o-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH
If the light is not to be used for some time, remove the batteries to
prevent possible leakage or corrosion. Please remove the batteries
during transportation to prevent it from misoperation.
WARRANTY RETURN POLICY
Please contact your local distributor or retailer for information on how
to handle your warranty items.